Atlas Copco FOCUS 60 - Page 54

Programming Focus 60 / Focus 61 Focus 60 / Focus 61 User Guide
54 (106) 9839 0211 01 Edition 1.1
For each MWR-TA the following information are displayed:
Wrench Type
MWR-TA model
Serial Number
Serial number marked on the MWR wrench
Base SN
Serial number of the Focus 60 / Focus 61
FW
Firmware version loaded on the MWR-TA
Minimum Torque
Minimum torque values for the MWR-TA model
Maximum Torque
Maximum torque values for the MWR-TA model
Overload Torque
Maximum overload torque for the MWR-TA model
Last Seen
“Keep alive” mode of the MWR-TA by the controller
NOTE: This box is highlighted by different colors according to the
time of connection failure
RSSI Base
Received Signal Strenght Indication (indicated in dBm)
RSSI Device
Received Signal Strenght Indication of the Device (indicated in dBm)
Battery status
Green → Battery charge ok
Red → Battery charge low
Empty → MWR-TA not available (but already linked)
In Cradle
Activated if the MWR-TA is on the Charging Cradle MWR
Click the Refresh icons to refresh the list of wrenches both in the Busy Wrenches field and in the Available
Wrenches field:
Refresh
icon
Refresh
icon