Atlas Copco FOCUS 60

Focus 60 / Focus 61 User Guide Programming Focus 60 / Focus 61
9839 0211 01 Edition 1.1 57 (106)
To make a “Busy Wrench” available:
 Connect the controller that is associated with the wrench.
 Remove the wrench.
 In case that the controller is off or disconnected, it is possible to unlink the wrench by right-
clicking and selecting Unlink Wrench:
NOTE: The Unlink Wrench option does not work if the associated controller is on and in
radio range.
NOTE: Please, be sure that the wrench is not in use on the other controller. If it is, it can cause
malfunctions.
In some cases, a Busy Wrench is Red (see the picture below); it means that the controller has disassociated
the MWR-TA, but it has not yet received this warning because it is out of radio range.