Atlas Copco FOCUS 60 - Page 56

Programming Focus 60 / Focus 61 Focus 60 / Focus 61 User Guide
56 (106) 9839 0211 01 Edition 1.1
To remove a MWR-TA from the Station
either drag and drop it into the trash bin or
right-click and select Remove Wrench
(see the figure on the right):
The following icon (see the figure
on the right) marks the MWR-TA
associated with the Station, but not
connected:
NOTE: The status of the MWR-TA shown in the figure above is refreshed dinamically in real
time.
The MWR wrenches shown as Busy are associated to other Focus controllers.
NOTE: If a MWR-TA is not
used/linked to a job, then it can
be removed.
NOTE: Relink Wrench option
relinks the selected wrench to a
specific Station.
Trash bin
Drag and drop
MWR-TA powered off or out
of radio range
Busy Wrenches