Atlas Copco FOCUS 60 - Page 67

Focus 60 / Focus 61 User Guide Programming Focus 60 / Focus 61
9839 0211 01 Edition 1.1 67 (106)
ABORT JOBS
Message
Message area selects the signal that stop a Job.
Select the signal between the following options:
 Barcode
 AOP_setvin
 AOP_Identifier
Define the following parameters:
 Length: the number of the characters
of the input signal (barcode or AOP)
 Significant Position: the position of
the characters that makes the
substring that starts the Job
 Significant String: click Set Strings
button; the pop-up on the right opens
for Job.
RESULTS
Results area defines the editable
information displayed in the results
table (for further details about the
results table, refer to the chapter
“Results Viewer”).
Results Source
Station_IDN
Station name
Job_IDN
Job name
Job_Step_IDN
Job Step name
Writable
The IDN may be changed anytime during the active job, but it may just be updated
during a Job Step start. An active Job Step is not affected.
Write_Once
The IDN can be set only once. Afterwards, all changes are rejected, except in the case
the Job ends or is aborted.
Job list: from the menu
select the Job to use