Atlas Copco HiLight B6+ Kd ESF User Manual

- 51 -
Inspect/Adjust fan/alternator belt x
Replace alternator belt x
Check/test emergency stop (13) x x
Clean radiator (1) x
Drain condensate and water from spillage-free frame (8) xx
Check for leaks in engine-, air-, oil-, or fuel system (8) xx
Hoses and clamps - Inspect/Replace x
Check electrical system cables for wear xx
Check/Test glow plugs xx
Check torque on critical bolt connections (12) xx
Check electrolyte (if applicable) battery terminals (10) xx
Analyse coolant (4) (7) xx
Grease locks and hinges xx
Check rubber flexibles (9) - replace every 6 years x
Drain/Clean fuel tank water and sediment (1) (14) x
Adjust engine inlet and exhaust valves (2) x
Check engine protective devices (15) xx
Inspect starter motor xx
Inspect charging alternator xx
Alternator
Measure alternator diodes xx
Maintenance schedule
Daily
50 hours after
start-up
Every 100 hours Every 600 hours Yearly
Service pack
- - - 1636 3105 95 -
00_00_HiLight B6+_EN.book Page 51 Thursday, September 2, 2021 11:50 AM

Atlas Copco HiLight B6+ Kd ESF Specifications

General

Brand	Atlas Copco
Model	HiLight B6+ Kd ESF
Category	Lighting Equipment
Language	English