176
ATtiny26(L)
1477G–AVR–03/05
Datasheet Revision
History
Please note that the referring page numbers in this section are referred to this docu-
ment. The referring revision in this section are referring to the document revision.
Changes from Rev.
1477F-12/04 to Rev.
1477G-03/05
1. MLF-package alternative changed to “Quad Flat No-Lead/Micro Lead Frame
Package QFN/MLF”.
2. Updated “Electrical Characteristics” on page 126
3. Updated “Ordering Information” on page 171
Changes from Rev.
1477E-10/03 to Rev.
1477F-12/04
1. Updated Table 16 on page 32, Table 9 on page 27, and Table 29 on page 57.
2. Added Table 20 on page 39.
3. Added “Changing Channel or Reference Selection” on page 98.
4. Updated “Offset Compensation Schemes” on page 105.
5. Updated “Electrical Characteristics” on page 126.
6. Updated package information for “20P3” on page 172.
7. Rearranged some sections in the datasheet.
Changes from Rev.
1477D-05/03 to Rev.
1477E-10/03
1. Removed Preliminary references.
2. Updated “Features” on page 1.
3. Removed SSOP package reference from “Pin Configuration” on page 2.
4. Updated V
RST
and t
RST
in Table 16 on page 32.
5. Updated “Calibrated Internal RC Oscillator” on page 28.
6. Updated DC Characteristics for V
OL
, I
IL
, I
IH
, I
CC
Power Down and
V
ACIO
in “Elec-
trical Characteristics” on page 126.
7. Updated V
INT
, INL and Gain Error in “ADC Characteristics” on page 129 and
page 130. Fixed typo in “Absolute Accuracy” on page 130.
8. Added Figure 106 in “Pin Driver Strength” on page 146, Figure 120, Figure 121
and Figure 122 in “BOD Thresholds and Analog Comparator Offset” on page
155. Updated Figure 117 and Figure 118.
9. Removed LPM Rd, Z+ from “Instruction Set Summary” on page 169. This
instruction is not supported in ATtiny26.
Changes from Rev.
1477C-09/02 to Rev.
1477D-05/03
1. Updated “Packaging Information” on page 172.
2. Removed ADHSM from “ADC Characteristics” on page 129.
3. Added section “EEPROM Write During Power-down Sleep Mode” on page 19.
To Next Page
Loading...
Need help?
General
