Setting ATW-R1440
58
Item Details
Notification Set to receive notifications from the receiver during remote control.
LVL Notify
[1]
Set whether to include AF and RF levels in notifications from the
receiver during remote control.
Multicast IP
[1]
Set the address for multicast.
Multicast port
[1]
Set the port number for multicast.
[1] This can be set only when “Notification” is set to “ON”.
4
Set each item.
5
Select “Apply” and press the control dial.
The setting is complete.
Log message setup
Set whether to send the log message to the Syslog server.
The default setting is “Off”.
1
From the receiver settings menu, select “NETWORK” and press the control dial.
2
Turn the control dial to select “SYSLOG” and press the control dial.
3
Turn the control dial to select “On”/“Off” and press the control dial.
The setting is complete.
Syslog is a standard for transferring log messages across IP networks. It is used for administration of
computer systems and security monitoring.
Setting automatic detection by the software
The default setting is “On”.
1
From the receiver settings menu, select “NETWORK” and press the control dial.
2
Turn the control dial to select “DISCOVERY” and press the control dial.
To Next Page
Loading...
