Setting ATW-R1440
59
3
Turn the control dial to select “On”/“Off” and press the control dial.
4
Turn the control dial to select “Reboot”/“Later” and press the control dial.
If you selected “Reboot”, the receiver restarts to complete the setting.
If you selected “Later”, the setting is complete but is not applied until the receiver restarts.
Setting the NTP (Network Time Protocol)
Set the NTP.
1
From the receiver settings menu, select “NETWORK” and press the control dial.
2
Turn the control dial to select “NTP” and press the control dial.
3
Select an item you want to set and press the control dial.
Item Details
NTP Set whether to enable or disable the NTP.
Server Adrs
[1]
Set the NTP server address.
Port Number
[1]
Set the NTP port number.
Time Zone
[1]
Set the time difference from the UTC (Coordinated Universal Time).
DST
[1]
Turn on/off daylight saving time.
Start Date
[2]
Set the starting date of daylight saving time.
Start Time
[2]
Set the starting time of daylight saving time.
End Date
[2]
Set the ending date of daylight saving time.
End Time
[2]
Set the ending time of daylight saving time.
[1] This can be set only when “NTP” is set to “ON”.
[2] This can be set only when “DST” is set to “ON”.
4
Set each item.
5
Select “Apply” and press the control dial.
The setting is complete.
To Next Page
Loading...
