Audio Technica System 20 PRO - Page 65

Setting ATW-R1440
64
Setting the HPF (High-Pass Filter)
1
Press the CH MENU button to select the channel to set.
Each press of this button switches the channel to set.
2
Turn the control dial to select “HPF” and press the control dial.
3
Turn the control dial to select “ON”/“OFF” and press the control dial.
The setting is complete.
Setting the transmitter ID
1
Press the CH MENU button to select the channel to set.
Each press of this button switches the channel to set.
2
Turn the control dial to select “TX SETTING” and press the control dial.
3
Turn the control dial to select “TX ID” and press the control dial.
4
Turn the control dial to select the character, and then press the control dial.
You can set two characters from 0 to 9 and from A to Z.
The setting is complete.
Setting the input gain
1
Press the CH MENU button to select the channel to set.
Each press of this button switches the channel to set.
2
Turn the control dial to select “TX SETTING” and press the control dial.
3
Turn the control dial to select “GAIN” and press the control dial.
4
Turn the control dial to select the input gain to use and press the control dial.
The gain changes +/− 2dB each time you turn the control dial.
It can be set from −10 to +20dB.