Setting ATW-R1440
65
The setting is complete.
Setting the input connector (ATW-T1401 only)
Set the connection destination of the input connector to “MIC” (microphone) or “INST” (guitar cable, etc.).
1
Press the CH MENU button to select the channel to set.
Each press of this button switches the channel to set.
2
Turn the control dial to select “TX SETTING” and press the control dial.
3
Turn the control dial to select “INPUT” and press the control dial.
4
Turn the control dial to select “MIC”/“INST” and press the control dial.
The setting is complete.
Setting the mute mode (ATW-T1401/ATW-T1402)
1
Press the CH MENU button to select the channel to set.
Each press of this button switches the channel to set.
2
Turn the control dial to select “TX SETTING” and press the control dial.
3
Turn the control dial to select “MUTE MODE” and press the control dial.
4
Turn the control dial to select “Enable”/“Disable” and press the control dial.
Item Details
Enable
The device switches between muted and unmuted to match the
side that the mute switch is slid to.
Disable The device is not muted even if the mute switch is slid to that side.
The setting is complete.
To Next Page
Loading...
