105
Figure 117.
I The remote has a built-in backlight that may be activated by
pressing the
Light Button . This button is made from a
special “glow” material so that it is easier to find in dark rooms.
This glow feature does not consume any electricity, but the
glow will fade when the remote is kept in a dark location for an
extended period of time. The “glow” feature may be restored
by placing the remote in normal room light for a few hours.
I The remote’s backlight will remain illuminated for approximately
5 seconds after the
Light Button is pressed, and it will stay
illuminated for another 5 seconds if any key is pressed while
the backlight is on. You may keep the backlight illuminated by
holding the Light button, but extensive use of the backlighting
will reduce battery life.
I The LCD will remain on for 10 seconds after a key is pressed
and then turn off to conserve battery life.
I When any button is held for more than 30 seconds, the LCD
will turn off and the remote will stop transmitting the codes,
to conserve battery life.
To Next Page
Loading...