Source Video In
1. Using RG6 quad shield coaxial cable terminated with male F con-
nectors, connect each of the
Video Source Out Terminals on
the AVR21EN rear panel to the appropriate
Source Video Input
on the AVH21, as shown in Figure 27.
2. In larger systems, complete Step 1 above by connecting the
Video Source Outs on the AVR21EN to the appropriate
Source Video Input on AVH21 #1, as shown in Figure 27.
a) Using short lengths of RG6 coax, connect each of the Source
Video Output Bypass Terminals
on AVH21 #1 to the
appropriate
Source Video Input on AVH21 #2, as shown
in
Figure 27.
b) If using three hubs, connect each of the Source Video Output
Bypass Terminals
on AVH21 #2 to the appropriate
Source Video Input on AVH21 #3, as shown in Figure 27.
Camera Video In
1. Using RG6 quad shield coaxial cable terminated with male F
connectors, connect each zone video monitor or security camera
composite video output to the appropriate
Camera Video Input
on the AVH21. Terminate the camera ends of the coax as
appropriate.
2. In larger systems, complete Step 1 above by connecting zone
video monitor or security camera composite video output to
the appropriate
Camera Video Input on AVH21 #1, as
shown in
Figure 27. Terminate the camera ends of the coax
as appropriate.
a) Using short lengths of RG6 coax, connect each of the
Camera
Video Output Bypass Terminals
on AVH21 #1 to the
appropriate
Camera Video Input on AVH21 #2, as
shown in
Figure 27.
b) If using three Hubs, connect each of the Camera Video
Output Bypass Terminals
on AVH21 #2 to the
appropriate
Camera Video Inputs on AVH21 #3, as
shown in
Figure 27.
46
Multiroom Installation and Setup
Figure 27.
Source and Camera Video Input Connections
To Next Page
Loading...