27
Main Menu Button: One backlit button allows return to the
Main Menu from any selected keypad menu page.
Back Button: One backlit button will return to the previous
page within a selected menu and then ultimately return to the
Main Menu. (This is slightly different from the Menu Page Down
button, which only functions within a selected multipage submenu
and stops at the bottom of that menu.)
LCD Information Display: One 3-1/4" backlit LCD displays
A/V Entertainment, Paging, Monitor, Setup, Wakeup, Sleep and
Door Lock menus and hard button control functions. Time, Day
and zone volume are also shown. The LCD has three selectable
backlight colors (that correspond to the hard button backlighting)
and adjustable backlight time out.
Volume Down Button: One backlit button adjusts zone/key-
pad Volume Down when pressed.
Volume Up Button: One backlit button adjusts zone/keypad
Volume Up when pressed.
Menu Page Forward Button: One backlit button allows
selection of the next page in a menu tree. When the top level of
a menu tree has been reached, the button has no function. A
right-pointing arrow with a corresponding page number will
appear on the LCD Information Display, just above the volume bar
indicating page-forward options. If the arrow and page number
are not visible, the top level of the menu tree has been reached.
Menu/Function Select Button: One backlit button allows
selection of various menu options and execution of various source
control functions, depending upon the Menu page and mode
currently selected. In the Main Menu, this button selects PARTY
MODE which activates all zones in the same Entertainment Group,
switching them to a predetermined source at a predetermined
audio level.
Menu/Function Select Button: One backlit button allows
selection of various menu options and execution of various source
control functions, depending upon the Menu page and mode
currently selected. In the Main Menu, this button selects DOOR,
which provides access to the Door Lock Relay screen for remote
control of electronic door locks.
Reset Button: One switch clears/resets the KP21 should the
microprocessor lock up.
Menu/Function Select Button: One backlit button allows
selection of various menu options and execution of various source-
control functions, depending upon the Menu page and mode
currently selected. In the Main Menu, this button selects SLEEP,
which provides access to the Sleep menu, allowing multiple set-
tings for zone and group turn-off times.
Menu/Function Select Button: One backlit button allows
selection of various menu options and execution of various source-
control functions, depending upon the Menu page and mode
currently selected. In the Main Menu this button selects WAKEUP,
which provides access to the Wakeup menu, allowing multiple
settings for zone and group turn-on times.
Keypad Mounting Screw Holes: Four circular openings used
to attach the keypad two a two-gang electrical box using the four
included screws.
Page/Monitor Microphone: One miniature microphone
allows whole-house paging, group paging, talking between rooms
and monitoring audio in a selected room via W.H.E.N. multiroom
link connections.
Keypad/Zone/System Power On/Off Button: One backlit
button turns the local keypad/zone ON when the system is active
in other zones. When the system is OFF, this button will activate
the AVR21EN, all common-source components and the local zone.
When the zone is active, the power button brightens to full illumi-
nation. If the power button is pressed when a keypad/zone is
active (ON), the zone will turn off. If the local zone is the last zone
active in the system, pressing the power button will turn off the
local zone, the AVR21EN and all common-source components.
When the zone is inactive (OFF) the power button dims to half
brightness. (The power button is never fully off unless power has
been removed from the keypad.)
IR Sensor: One photodiode “sees” IR commands transmitted
by a handheld IR remote control, allowing armchair zone and
system control.
Keypad Bezel Snap Tabs: Two plastic tabs protrude from
either side of the KP21 and snap into slots on the back of a KP21
bezel to hold the screwless bezel in place.
Menu/Function Select Button: One backlit button allows
selection of various menu options and execution of various source
control functions, depending upon the Menu page and mode cur-
rently selected. In the Main Menu, this button selects ENTERTAIN-
MENT, which opens the common and local source control menus.
Menu/Function Select Button: One backlit button allows
selection of various menu options and execution of various source
control functions, depending upon the menu page and mode
currently selected. In the Main Menu, this button selects PAGING,
which opens the All, Group and Keypad Paging Menus.
Menu/Function Select Button: One backlit button allows
selection of various menu options and execution of various source
control functions, depending upon the Menu page and mode
currently selected. In the Main Menu, this button selects MONI-
TOR, which allows selective zone audio and/or video monitoring
as allowed in the system configuration.
Menu/Function Select Button: One backlit button allows
selection of various menu options and execution of various source
control functions, depending upon the Menu page and mode
currently selected. In the Main Menu, this button selects SETUP,
which allows configuration of various zone functions such as Turn-
on volume, tone controls, paging volume, multiple EQ options
and backlight settings.
Menu Page Down Button: One backlit button allows selection
of the previous page in a menu tree. When the top level of a
menu tree has been reached, the button has no function. A left-
pointing arrow with a corresponding page number will appear
on the keypad’s
LCD Information Display just above the
volume bar indicating page-down options. If the arrow and
page number are not visible, the bottom level of the menu
tree has been reached.
KP21 Front-Panel Features
To Next Page
Loading...