AudioCodes Mediant 1000

User's Manual 1030 Document #: LTRT-27045
Mediant 1000B Gateway & E-SBC
Parameter Description
[FaxTransportMode]

[2] Bypass
 [3] Events Only
Note: The parameter is overridden by the parameter IsFaxUsed. If
the parameter IsFaxUsed is set to 1 (T.38 Relay) or 3 (Fax Fallback),
then FaxTransportMode is always set to 1 (T.38 relay).
V.21 Modem Transport Type
configure voip > media fax-
modem > V21-modem-
transport-type
[V21ModemTransportType]
Determines the V.21 modem transport type.
 [0] Disable = (Default) Transparent.
 [2] Enable Bypass
 [3] Events Only = Transparent with Events.
Note: You can also configure this functionality per specific calls,
using IP Profiles (IpProfile_VxxTransportType). For more
information, see ''Configuring IP Profiles'' on page 393.
V.22 Modem Transport Type
configure voip > media fax-
modem > V22-modem-
transport-type
[V22ModemTransportType]
Determines the V.22 modem transport type.
 [0] Disable = Transparent.
 [2] Enable Bypass (default)
 [3] Events Only = Transparent with Events.
Note: You can also configure this functionality per specific calls,
using IP Profiles (IpProfile_VxxTransportType). For more
information, see ''Configuring IP Profiles'' on page 393.
V.23 Modem Transport Type
configure voip > media fax-
modem > V23-modem-
transport-type
[V23ModemTransportType]
Determines the V.23 modem transport type.
 [0] Disable = Transparent.
 [2] Enable Bypass (default)
 [3] Events Only = Transparent with Events.
Note: You can also configure this functionality per specific calls,
using IP Profiles (IpProfile_VxxTransportType). For more
information, see ''Configuring IP Profiles'' on page 393.
V.32 Modem Transport Type
configure voip > media fax-
modem > V32-modem-
transport-type
[V32ModemTransportType]
Determines the V.32 modem transport type.
 [0] Disable = Transparent.
 [2] Enable Bypass (default)
 [3] Events Only = Transparent with Events.
Note:
 The parameter applies only to V.32 and V.32bis modems.
 You can also configure this functionality per specific calls, using
IP Profiles (IpProfile_VxxTransportType). For more information,
see ''Configuring IP Profiles'' on page 393.
V.34 Modem Transport Type
configure voip > media fax-
modem > V34-modem-
transport-type
[V34ModemTransportType]
Determines the V.90/V.34 modem transport type.
 [0] Disable = Transparent.
 [2] Enable Bypass (default)
 [3] Events Only = Transparent with Events.
Note: You can also configure this functionality per specific calls,
using IP Profiles (IpProfile_VxxTransportType). For more
information, see ''Configuring IP Profiles'' on page 393.
bell-modem-transport-type
[BellModemTransportType]
Determines the Bell modem transport method.
 [0] = Transparent (default)
 [2] = Bypass
 [3] = Transparent with events