Version 7.2 71 Mediant 1000B Gateway & E-SBC
User's Manual 6. Web-Based Management
3. Under the Security group, configure the following parameters:
Figure 6-23: Configuring Web User Security
• 'Deny Authentication Timer': Interval (in seconds) that the user needs to wait
before logging in from the same IP address after reaching the maximum number
of failed login attempts (see next step).
• 'Deny Access On Fail Count': Number of failed login attempts (e.g., incorrect
username or password) after which the device blocks access to the user for a
user-defined duration (previous step).
4. Click Apply.
For a detailed description of the above parameters, see ''Web Parameters'' on page 928.
6.6 Changing Login Password for Administrator and
Monitor Users
If you are logged in as a user with Administrator level or Monitor level, you can change
your login password by performing the following procedure.
Note:
• Users with Security Administrator level or Master level can change passwords for
themselves and for other users in the Local Users table (see ''Configuring
Management User Accounts'' on page 65).
• You can only change the password if the duration configured in the 'Password
Change Interval' has elapsed (see ''Configuring Web Session and Access
Settings'' on page 70).
 To change the login password:
1. Open the Web Settings page (Setup menu > Administration tab > Web & CLI folder
> Web Settings).
Figure 6-24: Changing Login Password for Administrator and Monitor User Levels
2. In the 'Current Password' field, type in your current login password.
3. In the 'New Password' field, type in your new password.
4. In the 'Confirm New Password' field, type in your new password again.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
