AudioCodes Mediant 1000 - LDAP Parameters

User's Manual 1180 Document #: LTRT-27045
Mediant 1000B Gateway & E-SBC
Parameter Description
RADIUS VSA Access Level
Attribute
configure system > radius
settings > vsa-access-level
[RadiusVSAAccessAttribute]
Defines the code that indicates the access level attribute in the Vendor
Specific Attributes (VSA) section of the received RADIUS packet.
The valid range is 0 to 255. The default is 35.
RADIUS Servers Table
RADIUS Servers
configure system >
radius servers
[RadiusServers]
Defines RADIUS servers.
The format of the ini file table parameter is as follows:
[ RadiusServers ]
FORMAT RadiusServers_Index = RadiusServers_ServerGroup,
RadiusServers_IPAddress, RadiusServers_AuthenticationPort,
RadiusServers_AccountingPort, RadiusServers_SharedSecret;
[ \RadiusServers ]
For a detailed description of this table, see ''Configuring RADIUS
Servers'' on page 222.
62.13.1.3 LDAP Parameters
The Lightweight Directory Access Protocol (LDAP) parameters are described in the table
below.
Table 62-76: LDAP Parameters
Parameter Description
LDAP Service
configure system > ldap settings >
ldap-service
[LDAPServiceEnable]
Enables the LDAP feature.
 [0] Disable (default)
 [1] Enable
Note: For the parameter to take effect, a device reset is
required.
LDAP Authentication Filter
configure system > ldap settings >
auth-filter
[LDAPAuthFilter]
Defines the LDAP search filter attribute for searching the
login username in the directory's subtree for LDAP-based
user authentication and authorization.
You can use the dollar ($) sign to represent the username.
For example, if the parameter is set to
"(sAMAccountName=$)" and the user logs in with the
username "SueM", the LDAP query is run for
sAMAccountName=SueM.
Use LDAP for Web > Telnet Login
configure system > ldap settings >
enable-mgmt-login
[MgmtLDAPLogin]
Enables LDAP-based management-user login authentication
and authorization.
 [0] Disable (default)
 [1] Enable
Note: For the parameter to take effect, a device reset is
required.
[LDAPDebugMode] Determines whether to enable the LDAP task debug
messages. This is used for providing debug information
regarding LDAP tasks.
The valid value range is 0 to 3. The default is 0.