User's Manual 54 Document #: LTRT-27045
Mediant 1000B Gateway & E-SBC
a. On the toolbar, click Save; a confirmation message box appears:
Figure 6-4: Save Configuration Confirmation Box
b. Click Yes to confirm; the changes are save to flash memory.
• If a device reset is required:
a. On the toolbar, click Reset; the Maintenance Actions page opens.
b. Click Reset; the device saves the changes to flash memory and then resets.
Warning: When you click Apply, your changes are saved only to the device's volatile
memory and thus, revert to their previous settings if the device later undergoes a
hardware reset, a software reset (without saving to flash) or powers down. Therefore,
make sure that you save your configuration to the device's flash memory.
6.1.6 Configuring Table Parameters
A typical configuration table is shown below and subsequently described:
Figure 6-5: Description of Tables
Table 6-2: General Description of Configuration Tables
Item # Button
To Next Page
Loading...
