AudioCodes Mediant 1000 User Manual

Version 7.2 1073 Mediant 1000B Gateway & E-SBC
User's Manual 62. Configuration Parameters Reference
Parameter Description
Call Forward on Busy
Deactivation
configure voip >
gateway dtmf-supp-
service supp-service-
settingscfb-
deactivation-code
[SuppServCodeCFBDeact]
Defines the prefix code for deactivating Call Forward on Busy
Deactivation sent to the softswitch.
The valid value is a string. By default, no value is defined.
Note: The string must be enclosed in single apostrophe (e.g., ‘*72’).
Call Forward on No Reply
configure voip >
gateway dtmf-supp-
service supp-service-
settingscfnr-code
[SuppServCodeCFNR]
Defines the prefix code for activating Call Forward on No Reply sent to
the softswitch.
The valid value is a string. By default, no value is defined.
Note: The string must be enclosed in single apostrophe (e.g., ‘*72’).
Call Forward on No Reply
Deactivation
configure voip >
gateway dtmf-supp-
service supp-service-
settingscfnr-
deactivation-code
[SuppServCodeCFNRDeact]
Defines the prefix code for deactivating Call Forward on No Reply
Deactivation sent to the softswitch.
The valid value is a string. By default, no value is defined.
Note: The string must be enclosed in single apostrophe (e.g., ‘*72’).
configure voip >
gateway dtmf-supp-
service supp-service-
settingsuse-facility-
in-req
[UseFacilityInRequest]
Enables the device to indicate the type of call forwarding service in the
Request-URI of the outgoing SIP INVITE message, using a proprietary
header parameter "facility=<call forward service>".
 [0] = (Default) Disable
 [1] = Enable
62.10.5.14 Character Conversion Parameters
The Character Conversion table parameter is described in the table below.
Table 62-55: Char Conversion Table Parameters
Char Conversion Table
Char Conversion
configure voip > gateway
dtmf-supp-service dtmf-
and-dialing > char-
conversion
[CharConversion]
Defines Unicode-to-ASCII character conversion rules. The format of the
ini file table parameter is as follows:
[CharConversion]
FORMAT CharConversion_Index = CharConversion_CharName,
CharConversion_FirstByte, CharConversion_SecondByte,
CharConversion_ConvertedOutput;
[\CharConversion]
For a detailed description of the table, see ''Converting Accented
Characters from IP to Tel'' on page 573.

AudioCodes Mediant 1000 Specifications

General

Data link protocols	CAS: MF-R1: T1 CAS, ISDN PRI: ETSI/EURO ISDN, ANSI NI2, QSIG
Security algorithms	HTTPS, SRTP
Authentication method	RADIUS
Internal memory	512 MB
Built-in processor	Celeron 600 MHz
Processor frequency	600 MHz
Internal memory type	-
Number of processors installed	1
Voice codecs	G.711, G.723.1, G.726, G.729A, iLBC
Safety	UL60950-1, FCC 47 CFR
Certification	ETS 300019-2-1, ETS 300019-2-2 ETS 300019-2-3
Mounting type	Rack mounting
LED indicators	Yes
Power requirements	90-260 V AC

Weight and Dimensions

Size (imperial)	19 \