AudioCodes Mediant 1000

User's Manual 1128 Document #: LTRT-27045
Mediant 1000B Gateway & E-SBC
Parameter Description
dials after a configurable delay (terminate the number with #); a
confirmation tone is heard.
Hot-line Deactivate
configure voip > gateway analog
keypad-features > hotline-deact
[KeyHotLineDeact]
Defines the keypad sequence to deactivate the delayed hotline
option. After the sequence is pressed, a confirmation tone is
heard.
Keypad Feature - Transfer Parameters
Note: See the description of the KeyBlindTransfer parameter for this feature.
Keypad Feature - Call Waiting Parameters
Call Waiting Activate
configure voip > gateway analog
keypad-features > cw-act
[KeyCallWaiting]
Defines the keypad sequence to activate the Call Waiting option.
After the sequence is pressed, a confirmation tone is heard.
Call Waiting Deactivate
configure voip > gateway analog
keypad-features > cw-deact
[KeyCallWaitingDeact]
Defines the keypad sequence to deactivate the Call Waiting
option. After the sequence is pressed, a confirmation tone is
heard.
Keypad Feature - Reject Anonymous Call Parameters
Reject Anonymous Call Activate
configure voip > gateway analog
keypad-features > reject-anony-
call-activate
[KeyRejectAnonymousCall]
Defines the keypad sequence to activate the reject anonymous
call option, whereby the device rejects incoming anonymous calls.
After the sequence is pressed, a confirmation tone is heard.
Reject Anonymous Call
Deactivate
configure voip > gateway analog
keypad-features > reject-anony-
call-deactivate
[KeyRejectAnonymousCallDeact]
Defines the keypad sequence that de-activates the reject
anonymous call option. After the sequence is pressed, a
confirmation tone is heard.
62.10.11 FXO and FXS Parameters
The general FXO and FXS parameters are described in the table below.
Table 62-66: General FXO and FXS Parameters
Parameter Description
Update Port Info
[AnalogPortInfo_x ]
Defines an arbitrary name for an analog (FXS or FXO) port.
This can be used to easily identify the port.
The valid value is a string of up to 40 characters. By default,
the value is undefined.
Note:
 For the ini file parameter, the x denotes the port number.
 To configure a port name through the Web interface, see
''Configuring Name for Telephony Ports'' on page 735.