AudioCodes Mediant 1000 User Manual

Version 7.2 1183 Mediant 1000B Gateway & E-SBC
User's Manual 62. Configuration Parameters Reference
Parameter Description
groups
[LDAPServerGroups]
[ LdapServerGroups ]
FORMAT LdapServerGroups_Index =
LdapServerGroups_Name, LdapServerGroups_ServerType,
LdapServerGroups_SearchMethod,
LdapServerGroups_CacheEntryTimeout,
LdapServerGroups_CacheEntryRemovalTimeout,
LdapServerGroups_SearchDnsMethod;
[ \LdapServerGroups ]
For a description of the table, see ''Configuring LDAP Server
Groups'' on page 232.
62.13.2 Least Cost Routing Parameters
The Least Cost Routing (LCR) parameters are described in the table below.
Table 62-77: LCR Parameters
Parameter Description
Cost Groups Table
configure voip > sip-
definition least-cost-routing
cost-group
[CostGroupTable]
Defines the Cost Groups for LCR, where each Cost Group is
configured with a name, fixed call connection charge, and a call rate
(charge per minute).
[ CostGroupTable ]
FORMAT CostGroupTable_Index =
CostGroupTable_CostGroupName,
CostGroupTable_DefaultConnectionCost,
CostGroupTable_DefaultMinuteCost;
[ \CostGroupTable ]
For example: CostGroupTable 2 = "Local Calls", 2, 1;
For a description of the table, see ''Configuring Cost Groups'' on page
260.
Cost Groups > Time Band
Table
configure voip > sip-
definition least-cost-routing
cost-group-time-bands
[CostGroupTimebands]
Defines time bands and associates them with Cost Groups.
[CostGroupTimebands]
FORMAT CostGroupTimebands_TimebandIndex =
CostGroupTimebands_StartTime, CostGroupTimebands_EndTime,
CostGroupTimebands_ConnectionCost,
CostGroupTimebands_MinuteCost;
[\CostGroupTimebands]
For a description of the table, see ''Configuring Time Bands for Cost
Groups'' on page 261.
62.13.3 Call Setup Rules Parameters
The Call Setup Rules parameters are described in the table below.
Table 62-78: Call Setup Rules Parameters
Parameter Description
Call Setup Rules
configure voip > message
Defines Call Setup Rules that the device runs at call setup for LDAP-
based routing and other advanced routing logic requirements including

AudioCodes Mediant 1000 Specifications

General

Data link protocols	CAS: MF-R1: T1 CAS, ISDN PRI: ETSI/EURO ISDN, ANSI NI2, QSIG
Security algorithms	HTTPS, SRTP
Authentication method	RADIUS
Internal memory	512 MB
Built-in processor	Celeron 600 MHz
Processor frequency	600 MHz
Internal memory type	-
Number of processors installed	1
Voice codecs	G.711, G.723.1, G.726, G.729A, iLBC
Safety	UL60950-1, FCC 47 CFR
Certification	ETS 300019-2-1, ETS 300019-2-2 ETS 300019-2-3
Mounting type	Rack mounting
LED indicators	Yes
Power requirements	90-260 V AC

Weight and Dimensions

Size (imperial)	19 \