AudioCodes Mediant 1000

Version 7.2 1133 Mediant 1000B Gateway & E-SBC
User's Manual 62. Configuration Parameters Reference
Parameter Description
TrunkGroup_ProfileName, TrunkGroup_LastTrunkId,
TrunkGroup_Module;
[\TrunkGroup]
For a description of the table, seeConfiguring Trunk Groups
on
page 465.
Note: Trunk Group ID 1 is denoted as 0 in the table.
Trunk Group Settings Table
Trunk Group Settings
configure voip > gateway trunk-
group-setting
[TrunkGroupSettings]
Defines the rules for channel allocation per Trunk Group.
The format of the ini file table parameter is as follows:
[TrunkGroupSettings]
FORMAT TrunkGroupSettings_Index =
TrunkGroupSettings_TrunkGroupId,
TrunkGroupSettings_ChannelSelectMode,
TrunkGroupSettings_RegistrationMode,
TrunkGroupSettings_GatewayName,
TrunkGroupSettings_ContactUser,
TrunkGroupSettings_ServingIPGroupName,
TrunkGroupSettings_MWIInterrogationType,
TrunkGroupSettings_TrunkGroupName,
TrunkGroupSettings_UsedByRoutingServer;
[\TrunkGroupSettings]
For a description of the table, see ''Configuring Trunk Group
Settings'' on page 467.
Channel Select Mode
ch-select-mode
[ChannelSelectMode]
Defines the method for allocating incoming IP-to-Tel calls to a
channel. The parameter applies to the following:
 All Trunk Groups configured without a channel select mode
in the Trunk Group Settings table (see ''Configuring Trunk
Group Settings'' on page 467).
 All channels and trunks configured without a Trunk Group
ID.
for all Trunk Groups channels that are configured without a
Trunk Group ID,.
 [0] By Dest Phone Number
 [1] Cyclic Ascending (default)
 [2] Ascending
 [3] Cyclic Descending
 [4] Descending
 [5] Dest Number + Cyclic Ascending.
 [6] By Source Phone Number
 [7] Trunk Cyclic Ascending
 [8] Trunk & Channel Cyclic Ascending
 [9] Ring to Hunt Group
 [10] Select Trunk By Supplementary Service Table
 [11] Dest Number + Ascending
For a detailed description of the parameter's options, see
''Configuring Trunk Group Settings'' on page 467.
Default Destination Number
configure voip > gateway dtmf-supp-
Defines the default destination phone number, which is used if
the received message doesn't contain a called party number