AudioCodes Mediant 1000

User's Manual 1168 Document #: LTRT-27045
Mediant 1000B Gateway & E-SBC
Parameter Description
condition-table
[ConditionTable]
FORMAT ConditionTable_Index = ConditionTable_Condition,
ConditionTable_Description;
[ \ConditionTable ]
For a description of the table, see ''Configuring Message
Condition Rules'' on page 655.
SBC IP-to-IP Routing Table
IP-to-IP Routing Table
configure voip > sbc routing ip2ip-
routing
[IP2IPRouting]
Defines SBC IP-to-IP routing rules.
The format of the ini file table parameter is as follows:
[ IP2IPRouting ]
FORMAT IP2IPRouting_Index = IP2IPRouting_RouteName,
IP2IPRouting_RoutingPolicyName,
IP2IPRouting_SrcIPGroupName,
IP2IPRouting_SrcUsernamePrefix, IP2IPRouting_SrcHost,
IP2IPRouting_DestUsernamePrefix, IP2IPRouting_DestHost,
IP2IPRouting_RequestType,
IP2IPRouting_MessageConditionName,
IP2IPRouting_ReRouteIPGroupName, IP2IPRouting_Trigger,
IP2IPRouting_CallSetupRulesSetId, IP2IPRouting_DestType,
IP2IPRouting_DestIPGroupName,
IP2IPRouting_DestSIPInterfaceName,
IP2IPRouting_DestAddress, IP2IPRouting_DestPort,
IP2IPRouting_DestTransportType,
IP2IPRouting_AltRouteOptions, IP2IPRouting_GroupPolicy,
IP2IPRouting_CostGroup, IP2IPRouting_DestTags,
IP2IPRouting_SrcTags;
[ \IP2IPRouting ]
For a description of the table, see ''Configuring SBC IP-to-IP
Routing Rules'' on page 656.
Alternative Routing Reasons Table
Alternative Routing Reasons
configure voip > sbc routing sbc-
alternative-routing-reasons
[SBCAlternativeRoutingReasons]
Defines SBC alternative routing reason rules.
The format of the ini file table parameter is as follows:
[ SBCAlternativeRoutingReasons ]
FORMAT SBCAlternativeRoutingReasons_Index =
SBCAlternativeRoutingReasons_ReleaseCause;
[ \SBCAlternativeRoutingReasons ]
For a description of the table, see ''Configuring SIP Response
Codes for Alternative Routing Reasons'' on page 668.
IP Group Set Table
IP Group Set
[PGroupSet]
Defines IP Group Sets for call load-balancing.
The format of the ini file table parameter is as follows:
[ IPGroupSet ]
FORMAT IPGroupSet_Index = IPGroupSet_Name,
IPGroupSet_Policy;
[ \IPGroupSet ]
For a description of the table, see Configuring IP Group Sets
on page 674.
IP Group Set Member Table