EasyManua.ls Logo

AudioCodes Mediant 1000

AudioCodes Mediant 1000
1195 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
User's Manual 338 Document #: LTRT-27045
Mediant 1000B Gateway & E-SBC
Parameter Description
Note:
If the parameter is not configured, the value of the global
parameter, ProxyName is used instead (see ''Configuring Proxy
and Registration Parameters'' on page 365).
The parameter overrides inbound message manipulation rules that
manipulate the host name in Request-URI, To, and/or From SIP
headers. If you configure the parameter and you want to
manipulate the host name in any of these SIP headers, you must
apply your manipulation rule (Manipulation Set ID) to the IP Group
as an Outbound Message Manipulation Set (see the
IPGroup_OutboundManSet parameter), when the IP Group is the
destination of the call. If you apply the Manipulation Set as an
Inbound Message Manipulation Set (see the
IPGroup_InboundManSet parameter), when the IP Group is the
source of the call, the manipulation rule is overridden by the SIP
Group Name parameter.
If the IP Group is of User type, the parameter is used internally as a
host name in the Request-URI for Tel-to-IP initiated calls. For
example, if an incoming call from the device's trunk is routed to a
User-type IP Group, the device first creates the Request-URI
(<destination_number>@<SIP Group Name>), and then it
searches the registration database for a match.
Created By Routing Server
[IPGroup_CreatedByRouting
Server]
(Read-only) Indicates whether the IP Group was created by a third-
party routing server:
[0] No
[1] Yes
For more information on the third-party routing server feature, see
Centralized Third-Party Routing Server on page 269.
Used By Routing Server
used-by-routing-server
[IPGroup_UsedByRoutingSe
rver]
Enables the IP Group to be used by a third-party routing server for call
routing decisions.
[0] Not Used (default)
[1] Used
For more information on the third-party routing server feature, see
Centralized Third-Party Routing Server on page 269.
Proxy Set Connectivity
show voip proxy sets status
[IPGroup_ProxySetConnecti
vity]
(Read-only field) Displays the connectivity status with Server-type IP
Groups. As the Proxy Set defines the address of the IP Group, the
connectivity check (keep-alive) by the device is done to this address.
"NA": Functionality is not applicable due to one of the following:
User-type IP Group.
Server-type IP Group, but the keep-alive mechanism of its'
associated Proxy Set is disabled.
"Not Connected": Keep-alive failure (i.e., no connectivity with the IP
Group).
"Connected": Keep-alive success (i.e., connectivity with the IP
Group).
The connectivity status is also displayed in the Topology View page
(see ''Building and Viewing SIP Entities in Topology View'' on page
355).
Note:
The feature is applicable only to Server-type IP Groups.
To support the feature, you must enable the keep-alive mechanism

Table of Contents

Other manuals for AudioCodes Mediant 1000

Related product manuals