User's Manual 376 Document #: LTRT-27045
Mediant 1000B Gateway & E-SBC
Parameter Description
[MessagePolicy_MaxBodyLength]
is the value of the Content-Length header.
The valid value is up to 1,024 characters. The default is
1,024.
Max Num Headers
max-num-headers
[MessagePolicy_MaxNumHeaders]
Defines the maximum number of SIP headers.
The valid value is any number up to 32. The default is
32.
Note: The device supports up to 20 SIP Record-Route
headers that can be received in a SIP INVITE request
or a 200 OK response. If it receives more than this, it
responds with a SIP 513 'Message Too Large'
response.
Max Num Bodies
max-num-bodies
[MessagePolicy_MaxNumBodies]
Defines the maximum number of bodies (e.g., SDP) in
the SIP message.
The valid value is any number up to 8. The default is 8.
Policies
Send Rejection
send-rejection
[MessagePolicy_SendRejection]
Defines whether the device sends a SIP response if it
rejects a message request due to the Message Policy.
The default response code is SIP 400 "Bad Request".
To configure a different response code, use the
MessagePolicyRejectResponseType parameter.
[0] Policy Reject = (Default) The device discards the
message and sends a SIP response to reject the
request.
[1] Policy Drop = The device discards the message
without sending any response.
SIP Method Blacklist-Whitelist Policy
Method List
method-list
[MessagePolicy_MethodList]
Defines SIP methods (e.g., INVITE\BYE) to blacklist or
whitelist.
Multiple methods are separated by a backslash (\). The
method values are case-insensitive.
Method List Type
method-list-type
[MessagePolicy_MethodListType]
Defines the policy (blacklist or whitelist) for the SIP
methods specified in the 'Method List' parameter
(above).
[0] Policy Blacklist = The specified methods are
rejected.
[1] Policy Whitelist = (Default) Only the specified
methods are allowed; the others are rejected.
SIP Body Blacklist-Whitelist Policy
Body List
body-list
[MessagePolicy_BodyList]
Defines the SIP body type (i.e., value of the Content-
Type header) to blacklist or whitelist. For example,
application/sdp.
The values of the parameter are case-sensitive.
Body List Type
body-list-type
[MessagePolicy_BodyListType]
Defines the policy (blacklist or whitelist) for the SIP
body specified in the 'Body List' parameter (above).
[0] Policy Blacklist =The specified SIP body is
rejected.
[1] Policy Whitelist = (Default) Only the specified
To Next Page
Loading...
