AudioCodes Mediant 1000

User's Manual 416 Document #: LTRT-27045
Mediant 1000B Gateway & E-SBC
Parameter Description
does not play a held tone to the held party (and assumes that the
initiator of the call hold plays the held tone).
Note: The device plays a held tone only if the 'SBC Play Held Tone'
parameter is set to Yes.
Play Held Tone
play-held-tone
[IpProfile_SBCPlayHeldTone]
Enables the device to play a held tone to the held party. This is
useful if the held party does not support playing a local held tone, or
for IP entities initiating call hold that do not support the generation of
held tones.
 [0] No (default)
 [1] Yes
Note: If the parameter is set to Yes, the device plays the tone only if
the 'SBC Remote Hold Format' parameter is set to transparent,
send-only, send only 0.0.0.0, or not supported.
SBC Fax
Fax Coders Group
sbc-fax-coders-group-name
[IpProfile_SBCFaxCodersGro
upName]
Assigns a Coder Group which defines the supported fax coders for
fax negotiation for the SIP entity associated with the IP Profile. To
configure Coder Groups, see Configuring Coder Groups on page
385.
Note: The parameter is applicable only if you set the
IpProfile_SBCFaxBehavior parameter to a value other than [0].
Fax Mode
sbc-fax-behavior
[IpProfile_SBCFaxBehavior]
Enables the device to handle fax offer-answer negotiations for the
SIP entity associated with the IP Profile.
 [0] As Is = (Default) Device forwards fax transparently, without
interference.
 [1] Handle always = Handle fax according to fax settings in the IP
Profile for all offer-answer transactions (including the initial
INVITE).
 [2] Handle on re-INVITE = Handle fax according to fax settings in
the IP Profile for all re-INVITE offer-answer transactions (except
for initial INVITE).
Note: The fax settings in the IP Profile include
IpProfile_SBCFaxCodersGroupName, IpProfile_SBCFaxOfferMode,
and IpProfile_SBCFaxAnswerMode.
Fax Offer Mode
sbc-fax-offer-mode
[IpProfile_SBCFaxOfferMode]
Defines the coders included in the outgoing SDP offer (sent to the
called "fax") for the SIP entity associated with the IP Profile.
 [0] All coders = (Default) Use only (and all) the coders of the
selected Coder Group configured using the
SBCFaxCodersGroupID parameter.
 [1] Single coder = Use only one coder. If a coder in the incoming
offer (from the calling "fax") matches a coder in the
SBCFaxCodersGroupID, the device uses this coder. If no match
exists, the device uses the first coder listed in the Coders Group
ID (SBCFaxCodersGroupID).
Note: The parameter is applicable only if you set the
IpProfile_SBCFaxBehavior parameter to a value other than [0].
Fax Answer Mode
sbc-fax-answer-mode
[IpProfile_SBCFaxAnswerMod
e]
Defines the coders included in the outgoing SDP answer (sent to the
calling "fax") for the SIP entity associated with the IP Profile.
 [0] All coders = Use matched coders between the incoming offer
coders (from the calling "fax") and the coders of the selected
Coder Group (configured using the SBCFaxCodersGroupID