User's Manual 42 Document #: LTRT-27045
Mediant 1000B Gateway & E-SBC
10. Configure the prefix length:
(network-if-0)# prefix-length <prefix length / subnet mask, e.g., 16>
11. Configure the Default Gateway address:
(network-if-0)# gateway <IP address>
12. Exit the IP Interfaces table:
(network-if-0)# exit
13. Exit the Network configuration mode:
(config-network)# exit
14. Reset the device with a flash burn:
# reload now
15. Cable the device to your network. You can now access the device's management
interface using this new OAMP IP address.
To Next Page
Loading...
