AudioCodes Mediant 1000

Version 7.2 507 Mediant 1000B Gateway & E-SBC
User's Manual 24. Manipulation
Parameter Description
represent any number between 0 and 255. For example, 10.8.8.*
represents all IP addresses between 10.8.8.0 and 10.8.8.255.
Destination IP Group
dst-ip-group-id
[_DestIPGroupID]
Defines the IP Group to where the call is sent.
The default is Any (i.e., any IP Group).
Note: The parameter is applicable only to the Destination Phone
Number Manipulation for Tel-to-IP Calls table.
Source Trunk Group
src-trunk-group-id
[_SrcTrunkGroupID]
Defines the source Trunk Group ID for Tel-to-IP calls.
The default is -1 (i.e., any Trunk Group).
Note: The parameter is applicable only to the number manipulation
tables for Tel-to-IP calls.
Source Prefix
src-prefix
[_SourcePrefix]
Defines the source (calling) telephone number prefix and/or suffix. You
can use special notations for denoting the prefix. For example, [100-
199](100,101,105) denotes a number that starts with 100 to 199 and
ends with 100, 101 or 105. You can also use the $ sign to denote calls
without a calling number. For a description of available notations, see
''Dialing Plan Notation for Routing and Manipulation Tables'' on page
923.
The default is the asterisk (*) wildcard (i.e., any prefix).
Source Host Prefix
src-host-prefix
[_SrcHost]
Defines the URI host name prefix of the incoming SIP INVITE message
in the From header.
The default is the asterisk (*) wildcard (i.e., any prefix).
Note:
 The parameter is applicable only to the Destination Phone Number
Manipulation for IP-to-Tel Calls table and Source Phone Number
Manipulation for IP-to-Tel Calls table.
 If the P-Asserted-Identity header is present in the incoming INVITE
message, then the value of the parameter is compared to the P-
Asserted-Identity URI host name (instead of the From header).
Destination Prefix
dst-prefix
[_DestinationPrefix]
Defines the destination (called) telephone number prefix and/or suffix.
You can use special notations for denoting the prefix. For example,
[100-199](100,101,105) denotes a number that starts with 100 to 199
and ends with 100, 101 or 105. You can also use the $ sign to denote
calls without a called number. For a description of available notations,
see ''Dialing Plan Notation for Routing and Manipulation Tables'' on
page 923.
The default is the asterisk (*) wildcard (i.e., any prefix).
Destination Host Prefix
dst-host-prefix
[_DestHost]
Defines the Request-URI host name prefix of the incoming SIP INVITE
message.
The default is the asterisk (*) wildcard (i.e., any prefix).
Note: The parameter is applicable only to the Destination Phone
Number Manipulation for IP-to-Tel Calls table and Source Phone
Number Manipulation for IP-to-Tel Calls table.
Source IP Group
src-ip-group-id
[_SrcIPGroupID]
Defines the IP Group from where the IP call originated.
The default is Any (i.e., any IP Group).
Note: The parameter is applicable only to the Destination Phone
Number Manipulation for IP-to-Tel Calls table and Source Phone
Number Manipulation for IP-to-Tel Calls table.