User's Manual 592 Document #: LTRT-27045
Mediant 1000B Gateway & E-SBC
One-stage dialing incorporates the following FXO functionality:
Waiting for Dial Tone: Enables the device to dial the digits to the Tel side only after
detecting a dial tone from the PBX line. The ini file parameter IsWaitForDialTone is
used to configure this operation.
Time to Wait Before Dialing: Defines the time (in msec) between seizing the FXO
line and starting to dial the digits. The ini file parameter WaitForDialTime is used to
configure this operation.
Note: The ini file parameter IsWaitForDialTone must be disabled for this mode.
Answer Supervision: The Answer Supervision feature enables the FXO device to
determine when a call is connected, by using one of the following methods:
• Polarity Reversal: the device sends a 200 OK in response to an INVITE only
when it detects a polarity reversal.
• Voice Detection: the device sends a 200 OK in response to an INVITE only
when it detects the start of speech (fax or modem answer tone) from the Tel side.
Note that the IPM detectors must be enabled.
To Next Page
Loading...
