CHAPTER60 Configuration Parameters Reference
Mediant 4000 SBC | User's Manual
Parameter Description
'Answer Machine Detector Beep
Detection Timeout'
configure voip > media
ipmedia > amd-beep-
detection-timeout
[AMDBeepDetectionTimeout]
Defines the AMD beep detection timeout (i.e., the
duration that the beep detector functions from when
detection is initiated). This is used for detecting beeps
at the end of an answering machine message.
The valid value is in units of 100 milliseconds, from 0
to 1638. The default is 200 (i.e., 20 seconds).
'Answer Machine Detector Beep
Detection Sensitivity'
configure voip > media
ipmedia > amd-beep-
detection-sensitivity
[AMDBeepDetectionSensitivity]
Defines the AMD beep detection sensitivity for
detecting beeps at the end of an answering machine
message.
The valid value is 0 to 3, where 0 (default) is the least
sensitive.
Services
This section describes services-related parameters.
SIP-based Media Recording Parameters
The SIP-based media recording parameters are described in the table below.
Table 60-40:SIP-based Media Recording Parameters
Parameter Description
'SIP Recording Application'
configure voip > sip-
definition sip-
recording settings >
enable-sip-rec
[EnableSIPRec]
Enables the SIP-based Media Recording feature:
■ [0] Disable (default)
■ [1] Enable
Note: For the parameter to take effect, a device reset is
required.
'Recording Server (SRS)
Destination Username'
configure voip > sip-
definition sip-
recording settings >
siprec-server-dest-
username
[SIPRecServerDestUsername]
Defines the SIP user part for the recording server. This user
part is added in the SIP To header of the INVITE message
that the device sends to the recording server.
The valid value is a string of up to 50 characters. By
default, no user part is defined.
'SIP Recording Metadata
Format'
configure voip > sip-
definition sip-
recording settings >
siprec-metadata-format
[SIPRecMetadataFormat]
Defines the format of the SIPRec recording metadata that
the device generates in SIP messages sent to the SRS.
■ [0] Legacy = (Default) The device generates the
recording metadata in a "legacy" format, whereby the
user part of the participant URI (source or destination)
is used as the ID.
- 992 -
To Next Page
Loading...
