AudioCodes Mediant 4000 SBC - Configuring Remote HTTP Hosts

CHAPTER16 Services
Mediant 4000 SBC | User's Manual
Configuring Remote HTTP Hosts
The HTTP Remote Hosts table lets you configure up to 10 remote HTTP hosts per Remote Web
Service. The HTTP Remote Hosts table is a "child" of the Remote Web Services table (configured
in Configuring Remote Web Services).
The following procedure describes how to configure HTTP Remote hosts through the Web
interface. You can also configure it through ini file [HTTPRemoteHosts] or CLI (configure
system > http-services > http-remote-hosts).
➢ To configure a remote HTTP host:
1. Open the Remote Web Services table (Setup menu > IP Network tab > Web Services folder
> Remote Web Services).
2. In the table, select the required remote Web service index row, and then click the HTTP
Remote Hosts link located below the table; the HTTP Remote Hosts table appears.
3. Click New; the following dialog box appears:
4. Configure an HTTP remote host according to the parameters described in the table below.
5. Click Apply, and then save your settings to flash memory.
Table 16-19:HTTP Remote Hosts Table Parameter Descriptions
Parameter Description
General
'Index'
rest-servers
[HTTPRemoteHosts_
RemoteHostindex]
Defines an index number for the new table row.
Note:
■ Each row must be configured with a unique index.
■ The parameter is mandatory.
'Name'
[HTTPRemoteHosts_
Name]
Defines a descriptive name, which is used when associating the row
in other tables.
The valid value is a string of up to 40 characters. By default, no value
is defined.
Note:
■ Each row must be configured with a unique name.
■ The parameter is mandatory.
Transport
'Address'
rest-address
Defines the address (IP address or FQDN) of the remote host.
The valid value is a string of up to 80 characters.
- 253 -