EasyManuals Logo

AudioCodes Mediant 4000 SBC User Manual

AudioCodes Mediant 4000 SBC
1037 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #478 background imageLoading...
Page #478 background image
CHAPTER20 SIP Definitions
Mediant 4000 SBC | User's Manual
To view the registration status of endpoints with a SIP Registrar/Proxy server, see
Viewing Registration Status.
➢ To configure the Proxy and registration parameters:
1. Open the Proxy & Registration page (Setup menu > Signaling & Media tab > SIP
Definitions folder > Proxy & Registration).
2. Configure the parameters as required.
3. Click Apply.
➢ To register or un-register the device to a Proxy/Registrar:
â–  Click the Register button to register.
â–  Click Un-Register button to un-register.
Instead of registering the entire device, you can register specific entities as listed below by using
the Register button located on the page in which these entities are configured:
â–  Trunk Groups - Trunk Group table (see Configuring Trunk Groups)
â–  Accounts - Accounts table (see Configuring Registration Accounts)
SIP Message Authentication Example
The device supports basic and digest (MD5) authentication types, according to SIP RFC 3261. A
proxy server might require authentication before forwarding an INVITE message. A Registrar/Proxy
server may also require authentication for client registration. A proxy replies to an unauthenticated
INVITE with a 407 Proxy Authorization Required response, containing a Proxy-Authenticate header
with the form of the challenge. After sending an ACK for the 407, the user agent can then re-send
the INVITE with a Proxy-Authorization header containing the credentials.
User agents, Redirect or Registrar servers typically use the SIP 401 Unauthorized response to
challenge authentication containing a WWW-Authenticate header, and expect the re-INVITE to
contain an Authorization header.
The following example shows the Digest Authentication procedure, including computation of user
agent credentials:
1. The REGISTER request is sent to a Registrar/Proxy server for registration:
REGISTER sip:10.2.2.222 SIP/2.0
Via: SIP/2.0/UDP 10.1.1.200
From: <sip: 122@10.1.1.200>;tag=1c17940
To: <sip: 122@10.1.1.200>
Call-ID: 634293194@10.1.1.200
CSeq: 1 REGISTER
Contact: sip:122@10.1.1.200:
Expires:3600
2. Upon receipt of this request, the Registrar/Proxy returns a 401 Unauthorized response:
SIP/2.0 401 Unauthorized
Via: SIP/2.0/UDP 10.2.1.200
From: <sip:122@10.2.2.222 >;tag=1c17940
To: <sip:122@10.2.2.222 >
Call-ID: 634293194@10.1.1.200
Cseq: 1 REGISTER
- 445 -

Table of Contents

Other manuals for AudioCodes Mediant 4000 SBC

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the AudioCodes Mediant 4000 SBC and is the answer not in the manual?

AudioCodes Mediant 4000 SBC Specifications

General IconGeneral
BrandAudioCodes
ModelMediant 4000 SBC
CategoryController
LanguageEnglish

Related product manuals