CHAPTER60 Configuration Parameters Reference
Mediant 4000 SBC | User's Manual
Parameter Description
'Offset'
configure system >
clock > summer-time >
offset
[DayLightSavingTimeOffset]
Defines the DST offset (in minutes).
The valid range is 0 to 120. The default is 60.
Note: The offset setting is applied only on the hour. For
example, if you configure the parameter at 15:42, the device
applies the setting only at 16:00.
Debugging and Diagnostics Parameters
This subsection describes the device's debugging and diagnostic parameters.
General Parameters
The general debugging and diagnostic parameters are described in the table below.
Table 60-16:General Debugging and Diagnostic Parameters
Parameter Description
[EnableDiagnostics] Determines the method for verifying correct functioning of
the different hardware components on the device. On
completion of the check and if the test fails, the device
sends information on the test results of each hardware
component to the Syslog server.
■ [0] = (Default) Rapid and Enhanced self-test mode.
■ [1] = Detailed self-test mode (full test of DSPs, PCM,
Switch, LAN, PHY and Flash).
■ [2] = A quicker version of the Detailed self-test mode
(full test of DSPs, PCM, Switch, LAN, PHY, but partial
test of Flash).
Note: For the parameter to take effect, a device reset is
required.
'Delay After Reset [sec]'
configure voip > sip-
definition advanced-
settings > delay-after-
reset
[GWAppDelayTime]
Defines the time interval (in seconds) that the device's
operation is delayed after a reset.
The valid range is 0 to 45. The default is 7 seconds.
Note: This feature helps overcome connection problems
caused by some LAN routers or IP configuration
parameters' modifications by a DHCP server.
[EnableAutoRAITransmitBER] Enables the device to send a remote alarm indication (RAI)
when the bit error rate (BER) is greater than 0.001.
■ [0] = Disable (default)
■ [1] = Enable
SIP Test Call Parameters
The SIP Signaling Test Call parameters are described in the table below.
- 891 -
To Next Page
Loading...
