AudioCodes Mediant 4000 SBC - DHCP Parameters

CHAPTER60 Configuration Parameters Reference
Mediant 4000 SBC | User's Manual
Parameter Description
For more information, see
Configuring Default DNS
Servers on page119.
'Default Secondary DNS Server IP'
configure network > dns settings > dns-
default-secondary-server-ip
[DefaultSecondaryDnsServerIp]
Defines the address of the
default secondary DNS
server.
The valid value is an IP
address in dotted-decimal
notation. The default is
8.8.4.4.
For more information, see
Configuring Default DNS
Servers on page119.
DHCP Parameters
The Dynamic Host Control Protocol (DHCP) parameters are described in the table below.
Table 60-14:DHCP Parameters
Parameter Description
'Enable DHCP'
[DHCPEnable]
Enables DHCP client functionality.
■ [0] Disable (default)
■ [1] Enable
Note:
■ For the parameter to take effect, a device reset is required.
■ For a detailed description of DHCP, see DHCP-based
Provisioning.
■ The parameter is a "hidden" parameter. Once defined and
saved to flash memory, its value doesn't revert to default even
if the parameter doesn't appear in the ini file.
[DhcpOption160Support] Enables the use of DHCP Option 160.
■ [0] = (Default) Disable
■ [1] = Enable
For more information, see Provisioning the Device using DHCP
Option 160 on page695.
Note: For the parameter to take effect, a device reset is required.
[DHCP120OptionMode] Enables the acceptance of DHCP Option 120 in DHCP responses
sent by a DHCP server.
■ [0] = DHCP Option 120 is not supported and ignored if
received in the DHCP response.
■ [1] = (Default) DHCP Option 120 is supported and if received,
the device adds the SIP server information to the Proxy Set.
[DHCPSpeedFactor] Defines the device's DHCP renewal speed for a leased IP
address from a DHCP server.
- 888 -