AudioCodes Mediant 4000 SBC - HTTP Proxy Parameters

CHAPTER60 Configuration Parameters Reference
Mediant 4000 SBC | User's Manual
Parameter Description
■ [0] Disable (default)
■ [1] Enable
For more information, see
Configuring QoS-Based Routing
by Routing Server.
'Quality Status Rate'
configure system > http-services >
routing-qos-status-rate
[RoutingServerQualityStatusRate]
Defines the rate (in sec) at which
the device sends QoS reports to
the routing server.
The valid range is 15-3600. The
default is 60.
For more information, see
Configuring QoS-Based Routing
by Routing Server.
'Topology Status'
configure system > http-services >
routing-server-group-status
[RoutingServerGroupStatus]
Enables the reporting of the
device's topology status (using
the REST TopologyStatus API
command) to HTTP remote
hosts.
■ [0] Disable (default)
■ [1] Enable
For more information, see
Configuring HTTP Services.
HTTP Proxy Parameters
The HTTP Proxy service parameters are described in the table below.
Table 60-45:HTTP Proxy Service Parameters
Parameter Description
'HTTP Proxy Application'
configure network > http-proxy >
http-proxy-app
[HTTPProxyApplication]
Enables the HTTP Proxy application.
■ [0] Disable (default)
■ [1] Enable
Note: For the parameter to take effect,
a device reset is required.
'HTTP Proxy Debug Level'
configure network > http-proxy >
http-proxy-debug-level
[HTTPProxySyslogDebugLevel]
Enables debugging of HTTP services
and the filtering of the messages sent
to the Syslog server by severity
(debug) level.
■ [0] No Debug = (Default) Disable.
■ [1] Info = Enables debug and
sends basic information in Syslog.
■ [2] Notice = Enables debug and
sends normal but significant
information in Syslog.
- 999 -