AudioCodes Mediant 4000 SBC User Manual

CHAPTER40 Automatic Provisioning
Mediant 4000 SBC | User's Manual
Automatic Update for Single Device
This simple example describes how to configure the Automatic Update feature for updating a single
device. In this example, the device queries the provisioning server for software, configuration and
Auxiliary files every 24 hours.
➢ To set up Automatic Provisioning for single device (example):
1. Set up an HTTP Web server (e.g., http://www.company.com) and place all the required
configuration files on this server.
2. Configure the device with the IP address of the DNS server for resolving the domain name
(e.g., http://www.company.com) that is used in the URL of the provisioning server. You
configure this in the IP Interfaces table:
● ini File:
[ InterfaceTable ]
FORMAT InterfaceTable_Index = InterfaceTable_ApplicationTypes,
InterfaceTable_InterfaceMode, InterfaceTable_IPAddress, InterfaceTable_
PrefixLength, InterfaceTable_Gateway, InterfaceTable_VlanID, InterfaceTable_
InterfaceName, InterfaceTable_PrimaryDNSServerIPAddress, InterfaceTable_
SecondaryDNSServerIPAddress, InterfaceTable_
UnderlyingDevice;InterfaceTable 0 = 6, 10, 10.15.7.95, 16, 10.15.0.1, 1, "Voice",
80.179.52.100, 0.0.0.0, "vlan 1";
[ \InterfaceTable ]
● CLI:
# configure network
(config-network)# interface network-if 0
(network-if-0)# primary-dns 80.179.52.100
3. Configure the device with the following Automatic Update settings:
a. Automatic Update is done every 24 hours (1440 minutes):
◆ ini File:
AutoUpdateFrequency = 1440
◆ CLI:
# configure system
(config-system)# automatic update
(automatic-update)# update-frequency 1440
b. Automatic Update of software file (.cmp):
◆ ini File:
AutoCmpFileUrl = 'https://www.company.com/sw.cmp'
◆ CLI:
# configure system
(config-system)# automatic update
(automatic-update)# auto-firmware 'http://www.company.com/sw.cmp'
- 707 -

AudioCodes Mediant 4000 SBC Specifications

General

Brand	AudioCodes
Model	Mediant 4000 SBC
Category	Controller
Language	English