CHAPTER60 Configuration Parameters Reference
Mediant 4000 SBC | User's Manual
Networking Parameters
This subsection describes the device's networking parameters.
Multiple VoIP Network Interfaces and VLAN Parameters
The IP network interfaces and VLAN parameters are described in the table below.
Table 60-9: IP Network Interfaces and VLAN Parameters
Parameter Description
VLAN Parameters
[EnableNTPasOAM] Defines the application type for Network Time Protocol (NTP)
services.
■ [1] = OAMP (default)
■ [0] = Control
Note: For the parameter to take effect, a device reset is required.
Routing Parameters
The IP network routing parameters are described in the table below.
Table 60-10:IP Network Routing Parameters
Parameter Description
'Don't Send ICMP Unreachable Messages'
configure network > network-settings >
icmp-disable-unreachable
[DisableICMPUnreachable]
Defines whether or not the device
generates and sends ICMP
messages, if required.
■ [0] Disable = (Default) Device
sends ICMP Unreachable
messages.
■ [1] Enable = Device does not
send ICMP Unreachable
messages.
'Send and Receive ICMP Redirect Messages'
configure network > network-settings >
icmp-disable-redirec
[DisableICMPRedirects]
Enables sending and receiving ICMP
Redirect messages.
■ [0] Enable = (Default) Device
sends and accepts these
messages.
■ [1] Disable = Device rejects
these messages and also does
not send them.
Quality of Service Parameters
The Quality of Service (QoS) parameters are described in the table below.
- 884 -
To Next Page
Loading...
