AudioCodes Mediant 4000 SBC - Fax; Modem Transparent Mode

CHAPTER15 Media
Mediant 4000 SBC | User's Manual
● Set the 'Fax Transport Mode' parameter to Events Only (FaxTransportMode = 3).
● Set the 'V.21 Modem Transport Type' parameter to Events Only
(V21ModemTransportType = 3).
● Set the 'V.22 Modem Transport Type' parameter to Events Only
(V22ModemTransportType = 3).
● Set the 'V.23 Modem Transport Type' parameter to Events Only
(V23ModemTransportType = 3).
● Set the 'V.32 Modem Transport Type' parameter to Events Only
(V32ModemTransportType = 3).
● Set the 'V.34 Modem Transport Type' parameter to Events Only
(V34ModemTransportType = 3).
2. Configure the [BellModemTransportType] parameter to [3] (transparent with events).
Fax / Modem Transparent Mode
In this mode, fax and modem signals are transferred using the current voice coder without
notifications to the user and without automatic adaptations. It's possible to use Profiles (see
Coders and Profiles ) to apply certain adaptations to the channel used for fax / modem. For
example, to use the coder G.711, to set the jitter buffer optimization factor to 13, and to enable echo
cancellation for fax and disable it for modem.
➢ To configure fax / modem transparent mode:
1. On the Fax/Modem/CID Settings page, do the following:
● Set the 'Fax Transport Mode' parameter to Disable (FaxTransportMode = 0).
● Set the 'V.21 Modem Transport Type' parameter to Disable (V21ModemTransportType =
0).
● Set the 'V.22 Modem Transport Type' parameter to Disable (V22ModemTransportType =
0).
● Set the 'V.23 Modem Transport Type' parameter to Disable (V23ModemTransportType =
0).
● Set the 'V.32 Modem Transport Type' parameter to Disable (V32ModemTransportType =
0).
● Set the 'V.34 Modem Transport Type' parameter to Disable (V34ModemTransportType =
0).
2. Configure the [BellModemTransportType] parameter to [0] (transparent mode).
3. Configure the following optional parameters:
● Coders in the Coders table - see Configuring Coder Groups.
● 'Dynamic Jitter Buffer Optimization Factor' (DJBufOptFactor) - Configuring the Dynamic
Jitter Buffer.
● 'Echo Canceller' (EnableEchoCanceller) - see Configuring Echo Cancellation.
This mode can be used for fax, but is not recommended for modem transmission.
Instead, use the Bypass (see Fax/Modem Bypass Mode) or Transparent with Events
modes (see Fax / Modem Transparent with Events Mode) for modem.
- 164 -