AudioCodes Mediant 4000 SBC - SBC Parameters

CHAPTER60 Configuration Parameters Reference
Mediant 4000 SBC | User's Manual
SBC Parameters
The SBC and CRP parameters are described in the table below.
Table 60-37:SBC and CRP Parameters
Parameter Description
CRP-specific Parameters
configure voip > application >
enable-crp
[EnableCRPApplication]
Enables the CRP application.
■ [0] = Disable (default)
■ [1] = Enable
Note: For the parameter to take effect, a
device reset is required.
'CRP Survivability Mode'
configure voip > sbc settings >
crp-survivability-mode
[CRPSurvivabilityMode]
Defines the CRP mode.
■ [0] Standard Mode (default)
■ [1] Always Emergency Mode
■ [2] Auto-answer REGISTER
'CRP Gateway Fallback'
configure voip > sbc settings >
crp-gw-fallback
[CRPGatewayFallback]
Enables fallback routing from the proxy
server to the Gateway (PSTN).
■ [0] Disable (default)
■ [1] Enable
SBC-specific Parameters
configure voip > application >
enable-sbc
[EnableSBCApplication]
Enables the Session Border Control (SBC)
application.
■ [0] = Disable
■ [1] = Enable (default)
Note:
■ For the parameter to take effect, a
device reset is required.
■ The parameter is enabled by default
only if the License Key contains at least
one of the SBC-related capacity
features (e.g., "SBC-Signaling");
otherwise, the parameter is disabled.
SBC and CRP Parameters
'Unclassified Calls'
configure voip > sbc settings >
unclassified-calls
[AllowUnclassifiedCalls]
Determines whether incoming calls that
cannot be classified (i.e. classification
process fails) to a Source IP Group are
rejected or processed.
■ [0] Reject = (Default) Call is rejected if
classification fails.
■ [1] Allow = If classification fails, the
incoming packet is assigned to a source
IP Group (and subsequently processed)
as follows:
- 966 -