AudioCodes Mediant 4000 SBC - Page 1033

CHAPTER60 Configuration Parameters Reference
Mediant 4000 SBC | User's Manual
Parameter Description
■ [3] Warning = Enables debug and
sends warning conditions in
Syslog.
■ [4] Error = Enables debug and
sends error conditions in Syslog.
■ [5] Critical = Enables debug and
sends critical conditions in Syslog.
■ [6] Alert = Enables debug and
sends conditions in Syslog that
require immediate action.
■ [7] Emergency = Enables debug
and sends conditions indicating
unstable system in Syslog.
Note: The NGINX Directive for this
parameter is "error_log, access_log".
'Primary DNS Server IP'
dns-primary-server
[HTTPPrimaryDNS]
Defines the primary DNS server (in
dotted-decimal notation), which is used
for translating domain names into IP
addresses for the HTTP service.
By default, no IP address is defined.
'Secondary DNS Server IP'
dns-secondary-server
[HTTPSecondaryDNS]
Defines the secondary DNS server (in
dotted-decimal notation), which is used
for translating domain names into IP
addresses for the HTTP service.
By default, no IP address is defined.
'HTTP Proxy Global Address'
configure network > http-proxy >
http-proxy-global-address
[HttpProxyGlobalAddress]
Defines the device's public IP address
for the HTTP Proxy service, when the
device is located behind NAT.
The valid value is an IP address in
dotted-decimal notation. The default is
0.0.0.0.
For more information, see Configuring
a Public IP Address for NGINX NAT
Traversal on page282.
- 1000 -