AudioCodes Mediant 4000 SBC - Page 254

CHAPTER16 Services
Mediant 4000 SBC | User's Manual
Parameter Description
'LDAP Network Interface'
interface-type
[LdapConfiguration_Interface]
Assigns one of the device's IP network interfaces
through which communication with the LDAP server is
done.
By default, no value is defined and the device uses the
OAMP network interface, configured in the IP Interfaces
table.
To configure IP network interfaces, see Configuring IP
Network Interfaces.
Note: The parameter is mandatory.
'Use TLS'
use-tls
[LdapConfiguration_useTLS]
Enables the device to encrypt the username and
password (for Control and Management related queries)
using TLS when sending them to the LDAP server.
■ [0] No = (Default) Username and password are sent
in clear-text format.
■ [1] Yes
'TLS Context'
tls-context
[LdapConfiguration_ContextName]
Assigns a TLS Context for the connection with the
LDAP server.
By default, no value is defined and the device uses the
default TLS Context (ID 0).
To configure TLS Contexts, see Configuring TLS
Certificate Contexts.
Note: The parameter is applicable only if the 'Use TLS'
parameter is configured to Yes.
Connection
'LDAP Server IP'
server-ip
[LdapConfiguration_
LdapConfServerIp]
Defines the IP address of the LDAP server (in dotted-
decimal notation, e.g., 192.10.1.255).
By default, no IP address is defined.
Note:
■ The parameter is mandatory.
■ If you want to use an FQDN for the LDAP server,
leave the parameter undefined and configure the
FQDN in the 'LDAP Server Domain Name'
parameter (see below).
'LDAP Server Port'
server-port
[LdapConfiguration_
LdapConfServerPort]
Defines the port number of the LDAP server.
The valid value range is 0 to 65535. The default port
number is 389.
'LDAP Server Max Respond Time'
max-respond-time
[LdapConfiguration_
LdapConfServerMaxRespondTim
e]
Defines the duration (in msec) that the device waits for
LDAP server responses.
The valid value range is 0 to 86400. The default is 3000.
- 221 -