AudioCodes Mediant 4000 SBC - Page 279

CHAPTER16 Services
Mediant 4000 SBC | User's Manual
4. Configure a Time Band according to the parameters described in the table below.
5. Click Apply, and then save your settings to flash memory.
Table 16-17:Time Band Table Description
Parameter Description
'Index'
timeband-index
[CostGroupTimebands_
TimebandIndex]
Defines an index number for the new table row.
Note: Each row must be configured with a unique index.
'Start Time'
start-time
[CostGroupTimebands_
StartTime]
Defines the day and time of day from when this time band is
applicable. The format is DDD:hh:mm, where:
■ DDD is the day of the week, represented by the first three
letters of the day in upper case (i.e., SUN, MON, TUE, WED,
THU, FRI, or SAT).
■ hh and mm denote the time of day, where hh is the hour (00-23)
and mm the minutes (00-59)
For example, SAT:22:00 denotes Saturday at 10 pm.
'End Time'
end-time
[CostGroupTimebands_
EndTime]
Defines the day and time of day until when this time band is
applicable. For a description of the valid values, see the parameter
above.
'Connection Cost'
connection-cost
[CostGroupTimebands_
ConnectionCost]
Defines the call connection cost during the time band. This is
added as a fixed charge to the call.
The valid value range is 0-65533. The default is 0.
Note: The entered value must be a whole number (i.e., not a
decimal).
'Minute Cost'
minute-cost
[CostGroupTimebands_
MinuteCost]
Defines the call cost per minute charge during the time band.
The valid value range is 0-65533. The default is 0.
Note: The entered value must be a whole number (i.e., not a
decimal).
- 246 -