AudioCodes Mediant 4000 SBC - Page 281

CHAPTER16 Services
Mediant 4000 SBC | User's Manual
● You can configure only one Remote Web Service for each of the following server
types: Routing, Call Status, Topology Status, and QoS.
● The Routing service also includes the Call Status and Topology Status services.
● The device supports HTTP redirect responses (3xx) only during connection
establishment with the host. Upon receipt of a redirect response, the device
attempts to open a new socket with the host and if this is successful, closes the
current connection.
The following procedure describes how to configure Remote Web Services through the Web
interface. You can also configure it through ini file [HTTPRemoteServices] or CLI (configure
system > http-services > http-remote-services).
➢ To configure a remote Web service:
1. Open the Remote Web Services table (Setup menu > IP Network tab > Web Services folder
> Remote Web Services).
2. Click New; the following dialog box appears:
3. Configure a remote Web service according to the parameters described in the table below.
4. Click Apply, and then save your settings to flash memory.
Table 16-18:Remote Web Services Table Parameter Descriptions
Parameter Description
General
'Index'
[HTTPRemoteServices_
Index]
Defines an index number for the new table row.
Note:
■ Each row must be configured with a unique index.
■ The parameter is mandatory.
'Name'
rest-name
[HTTPRemoteServices_
Name]
Defines a descriptive name, which is used when associating
the row in other tables.
The valid value is a string of up to 40 characters.
Note:
■ Each row must be configured with a unique name.
■ The parameter is mandatory.
■ The parameter value cannot contain a forward slash (/).
'Type'
rest-message-type
Defines the type of service provided by the HTTP remote
host:
- 248 -