AudioCodes Mediant 4000 SBC - Page 284

CHAPTER16 Services
Mediant 4000 SBC | User's Manual
Parameter Description
■ [1] Enable (default)
Note: The parameter is applicable only if you configure the
'Type' parameter to any value except General.
Authentication
'Username'
rest-user-name
[HTTPRemoteServices_
AuthUserName]
Defines the username for HTTP authentication.
The valid value is a string of up to 80 characters. The default
is "user".
'Password'
rest-password
[HTTPRemoteServices_
AuthPassword]
Defines the password for HTTP authentication.
The valid value is a string of up to 80 characters. The default
is "password".
Security
'TLS Context'
rest-tls-context
[HTTPRemoteServices_
TLSContext]
Assigns a TLS Context for connection with the remote host.
By default, no value is defined.
To configure TLS Contexts, see Configuring TLS Certificate
Contexts.
Note: The parameter is applicable only if the connection is
HTTPS.
'Verify Certificate'
rest-verify-
certificates
[HTTPRemoteServices_
VerifyCertificate]
Enables certificate verification when connection with the
host is based on HTTPS.
■ [0] Disable = (Default) No certificate verification is done.
■ [1] Enable = The device verifies the authentication of the
certificate received from the HTTPS peer. The device
authenticates the certificate against the trusted root
certificate store associated with the associated TLS
Context (see 'TLS Context' parameter above) and if ok,
allows communication with the HTTPS peer. If
authentication fails, the device denies communication
(i.e., handshake fails). The device can also authenticate
the certificate by querying with an Online Certificate
Status Protocol (OCSP) server whether the certificate
has been revoked. This is also configured for the
associated TLS Context.
Note: The parameter is applicable only if the connection is
HTTPS.
'Verify Certificate Subject
Name'
verify-cert-subject-
name
[HTTPRemoteServices_
VerifyCertificateSubjectName]
Enables the verification of the TLS certificate subject name
(Common Name / CN or Subject Alternative Name / SAN)
when connection with the host is based on HTTPS.
■ [0] Off = (Default) No verification is done.
- 251 -