AudioCodes Mediant 4000 SBC - Page 303

CHAPTER16 Services
Mediant 4000 SBC | User's Manual
3. Configure a TCP/UDP Proxy Server according to the parameters described in the table below.
4. Click Apply, and then save your settings to flash memory.
Table 16-22:TCP/UDP Proxy Servers Table Parameter Descriptions
Parameter Description
General
'Index'
[TcpUdpServer_Index]
Defines an index number for the new table row.
Note:
■ Each row must be configured with a unique index.
■ The parameter is mandatory.
'Name'
name
[TcpUdpServer_Name]
Defines a descriptive name, which is used when associating the
row in other tables.
The valid value is a string of up to 40 characters. By default, no
value is defined.
Note:
■ Each row must be configured with a unique name.
■ The parameter is mandatory.
'Additional Directive Set'
directive-set
[TcpUdpServer_
AdditionalDirectiveSet]
Assigns an NGINX Directive Set for the HTTP service. To con-
figure HTTP Directive Sets, see Configuring HTTP Directive
Sets on page275.
Listen Parameters
'Listening Interface'
listen-interface
[TcpUdpServer_
ListeningInterface]
Assigns a local IP network interface for the listening (source)
interface for communication with the TCP-UDP proxy server. To
configure IP Interfaces, see Configuring IP Network Interfaces
on page96.
By default, no value is defined.
Note:
■ The parameter is mandatory.
■ The NGINX directive for this parameter is "listen ip".
'TCP Listening Port'
tcp-port
[TcpUdpServer_
TCPListeningPort]
Defines the TCP port of the listening interface.
Note:
■ You must configure a TCP and/or UDP port.
■ The NGINX directive for this parameter is "listen ip:port".
'UDP Listening Port' Defines the TCP port of the listening interface.
- 270 -