CHAPTER18 Core Entities
Mediant 4000 SBC | User's Manual
● If you delete an IP Group or modify the 'Type' or 'SRD' parameters, the device
immediately terminates currently active calls that are associated with the IP Group.
In addition, all users belonging to the IP Group are removed from the device's users
database.
The following procedure describes how to configure IP Groups through the Web interface. You can
also configure it through ini file [IPGroup] or CLI (configure voip > ip-group).
➢ To configure an IP Group:
1. Open the IP Groups table (Setup menu > Signaling & Media tab > Core Entities folder > IP
Groups).
2. Click New; the following dialog box appears:
3. Configure an IP Group according to to the parameters described in the table below.
4. Click Apply.
Table 18-6: IP Groups Table Parameter Descriptions
Parameter Description
'SRD'
srd-name
[IPGroup_SRDName]
Assigns an SRD to the IP Group.
If only one SRD is configured in the SRDs table, the
SRD is assigned by default. If multiple SRDs are
configured in the SRDs table, no value is assigned by
default and you must assign one.
To configure SRDs, see Configuring SRDs.
Note: The parameter is mandatory.
General
'Index'
[IPGroup_Index]
Defines an index for the new table row.
Note: Each row must be configured with a unique index.
- 347 -
To Next Page
Loading...
