AudioCodes Mediant 4000 SBC - Page 393

CHAPTER18 Core Entities
Mediant 4000 SBC | User's Manual
Parameter Description
[IPGroup_QOEProfile] To configure Quality of Experience Profiles, see
Configuring Quality of Experience Profiles.
'Bandwidth Profile'
bandwidth-profile
[IPGroup_BWProfile]
Assigns a Bandwidth Profile rule.
By default, no value is defined.
To configure Bandwidth Profiles, see Configuring
Bandwidth Profiles.
Message Manipulation
'Inbound Message Manipulation
Set'
inbound-mesg-
manipulation-set
[IPGroup_InboundManSet]
Assigns a Message Manipulation Set (rule) to the IP
Group for SIP message manipulation on the inbound leg.
By default, no value is defined.
To configure Message Manipulation rules, see
Configuring SIP Message Manipulation.
Note:
■ The IPGroup_SIPGroupName parameter overrides
inbound message manipulation rules (assigned to
the IPGroup_InboundManSet parameter) that
manipulate the host name in Request-URI, To,
and/or From SIP headers. If you want to manipulate
the host name using message manipulation rules in
any of these SIP headers, you must apply your
manipulation rule (Manipulation Set ID) to the IP
Group as an Outbound Message Manipulation Set
(see the IPGroup_OutboundManSet parameter),
when the IP Group is the destination of the call.
'Outbound Message Manipulation
Set'
outbound-mesg-
manipulation-set
[IPGroup_OutboundManSet]
Assigns a Message Manipulation Set (rule) to the IP
Group for SIP message manipulation on the outbound
leg.
By default, no value is defined.
To configure Message Manipulation rules, see
Configuring SIP Message Manipulation.
Note: If you assign a Message Manipulation Set ID that
includes rules for manipulating the host name in the
Request-URI, To, and/or From SIP headers, the
parameter overrides the IPGroup_SIPGroupName
parameter.
'Message Manipulation User-
Defined String 1'
msg-man-user-defined-
string1
[IPGroup_MsgManUserDef1]
Defines a value for the SIP user part that can be used in
Message Manipulation rules configured in the Message
Manipulations table. The Message Manipulation rule
obtains this value from the IP Group, by using the
following syntax:
param.ipg.<src|dst>.user-defined.<0>.
The valid value is a string of up to 30 characters. By
default, no value is defined.
To configure Message Manipulation rules, see
Configuring SIP Message Manipulation.
- 360 -