AudioCodes Mediant 4000 SBC - Page 482

CHAPTER20 SIP Definitions
Mediant 4000 SBC | User's Manual
➢ To configure User Information table through the Web interface:
1. Open the User Information table (Setup menu > Signaling & Media tab > SBC folder > User
Information).
2. Click New; the following dialog box appears:
3. Configure a user according to the table below.
4. Click Apply.
Table 20-2: User Information Table Parameter Descriptions
Parameter Description
'Index'
[SBCUserInfoTable_
Index]
Defines an index number for the new table row.
Note: Each row must be configured with a unique index.
'Local User'
[SBCUserInfoTable_
LocalUser]
Defines the user and is used as the Request-URI user part for the
AOR in the database.
The valid value is a string of up to 60 characters. By default, no value
is defined.
Note: The parameter is mandatory.
'Username'
[SBCUserInfoTable_
Username]
Defines the username for registering the user when authentication is
necessary.
The valid value is a string of up to 60 characters. By default, no value
is defined.
'Password'
[SBCUserInfoTable_
Password]
Defines the password for registering the user when authentication is
necessary.
The valid value is a string of up to 20 characters.
'IP Group'
[SBCUserInfoTable_
IPGroupName]
Assigns an IP Group to the user. The IP Group is used as the
Request-URI source host part for the AOR in the database.
To configure IP Groups, see Configuring IP Groups.
Note:
■ The parameter is mandatory.
■ You must assign the user with a User-type IP Group.
'Status'
[SBCUserInfoTable_
Status]
(Read-only field) Displays the status of the user:
■ "Registered": Valid configuration and the user is registered.
■ "Not Registered": Valid configuration but the user has not been
registered.
- 449 -