AudioCodes Mediant 4000 SBC - Page 507

CHAPTER20 SIP Definitions
Mediant 4000 SBC | User's Manual
2. In the IP Groups table, configure your IP Groups. Make sure that you assign the source IP
Group with the Dial Plan that you configured in Step 1 and that you configure each destination
IP Group with one of the required Dial Plan tags. If the tag has a value, include it as well. In our
example, we will configure three IP Groups:
Parameter Index 0 Index 1 Index 2
Name HQ ENG BEL
Dial Plan Dial Plan 1 - -
Tags - Country=England Country=Belgium
3. In the IP-to-IP Routing table, configure a routing rule where the 'Destination Type' parameter is
configured to Destination Tag and the 'Routing Tag Name' to one of your Dial Plan tags. In our
example, the tag "Country" is used:
Parameter Index 0
Name Europe
Source IP Group HQ
Destination Type Destination Tag
Routing Tag Name Country
- 474 -