AudioCodes Mediant 4000 SBC - Page 604

CHAPTER25 Routing SBC
Mediant 4000 SBC | User's Manual
3. Configure the Routing Policy rule according to the parameters described in the table below.
4. Click Apply.
Table 25-4: Routing Policies table Parameter Descriptions
Parameter Description
General
'Index' Defines an index number for the new table row.
Note: Each row must be configured with a unique index.
'Name'
name
[SBCRoutingPolicy_
Name]
Defines a descriptive name, which is used when associating the
row in other tables.
The valid value is a string of up to 40 characters. By default, no
name is defined. If you don't configure a name, the device
automatically assigns a name in the following format:
"SBCRoutingPolicy_<Index>", for example,
"SBCRoutingPolicy_2".
Note:
■ Each row must be configured with a unique name.
■ The parameter value cannot contain a forward slash (/).
'LDAP Servers Group
Name'
ldap-srv-group-
name
[SBCRoutingPolicy_
LdapServersGroupName]
Assigns an LDAP Server Group to the Routing Policy. Routing
rules in the IP-to-IP Routing table that are associated with the
Routing Policy and that are configured with LDAP and/or Call
Setup Rules, use the LDAP server(s) configured for this LDAP
Server Group.
By default, no value is defined.
For more information on LDAP Server Groups, see Configuring
LDAP Server Groups.
Note: The default Routing Policy is assigned the default LDAP
Server Group ("DefaultCTRLServersGroup").
- 571 -