CHAPTER37 Loading Auxiliary Files
Mediant 4000 SBC | User's Manual
● When loading an ini file through the Auxiliary Files page (as described in this
section), only parameter settings specified in the ini file are applied to the device; all
other parameters remain at their current settings.
● If you load an ini file containing Auxiliary file(s), the Auxiliary files specified in the
file overwrite the Auxiliary files currently installed on the device.
● For the User Information file, only use the Auxiliary Files page for backward
compatibility. If backward compatibility is not needed, load the file or configure
users in the User Information table for SBC users (see Configuring SBC User
Information Table through Web Interface on page448).
➢ To load Auxiliary files through Web interface:
1. Open the Auxiliary Files page:
● Toolbar: From the Actions drop-down menu, choose Auxiliary Files.
● Navigation tree: Setup menu > Administration tab > Maintenance folder > Auxiliary
Files.
2. Click the Browse button corresponding to the Auxiliary file type that you want to load, navigate
to the folder in which the file is located, and then click Open; the name of the file appears next
to the Browse button.
- 665 -
To Next Page
Loading...
